|
| Posted on 11/13/07 at 01:40 PM | |
|
|
I use a regular high heat solvent contact adhesive, probably comes in a tin, you just brush it on both surfaces of the palette and rubber, give it a second to become tacky as opposed to wet, then press them together, roll out any trapped air then chuck a few phone books or whatever on top to keep a good seal until it's dry. you'll more than likely have to wipe the adhesive that you put on there off to get a good contact between the metal palette and the rubber. Did you leave the palette under the flash too long? I've done that.....more than once. ____________________ If it aint broke.....fix it till it is! | |
 
|
