|
| Posted on 3/29/06 at 01:27 PM | |
|
Xante doesn't seem to know what my problem is , so perhaps by trial and error maybe someone else has had this problem. I have a Screenwriter 3 running on XP and using Corel 12. I have upgraded to 128mb on the printer. Most of the time on what I call normal jobs it prints fine, but when I start powerclipping, gradients and stuff like that is when the problem starts. Most of the time when the job is sent to the printer the data light flashes until the data is received and then the light goes out....But nothing prints. The printer dialog box has sent the job ....the printer just doesn't catch it. Other times it scrambles the graphics...Like it might take a node and really stretch it out. Kind of hard to explain what it does and if you send the job again it will do it to a different node(or two). I'm not talking about huge files here....Maybe a few hundred kb up to 3 or 4 mb. Very frustrating to say the least. If I rasterize it in the Misc. print box it will work sometimes....other times I receive an error <syntax> or <undefined> or <ioerror>. Those 3 error messages were on 3 attempts on the same job.......Any help would be much appreciated........... | ||
 
|